Small load and thin type spur gear slewing drives used for vertical installation
Publish time：2022/08/30 Latest Products Views：174
Model: S-I-O-0980
Type: thin type spur gear slewing drive
Slewing drive gear ratio: 17.8:1
Rated output torque: 7100N.M
Rotation center diameter: 980mm
Total height with adapter flange: 80mm
Gear backlash ≤0.35mm
S-I-O-0980 vertically installed light load and thin type slewing drives are used in the field of industrial automation. Our customers require that the inner diameters of the slewing drives should be large enough and the loads are small, and also require the slewing drives to be as thin and light weight as possible.
In fact, there are many similar requirements in equipment design. The workpieces to be turned are very light in weight, but their sizes are relatively large, customers also have the requirements to pass larger size components from the inner diameters of the slewing drives. These require the gear type slewing drives to be made into light and thin.
First of all, the strength of the slewing drives must be considered and do not design too thin slewing drives to meet the customers’ load requirements. Then it’s necessary to consider the difficulties of manufacturing. Large and thin products are often difficult to process and the machining accuracies are difficult to guarantee.
Therefore, it’s necessary to fully consider the processing difficulties when designing and on the premise of ensuring that they are relatively easy to process, try to be as thin and light as possible to meet customers’ requirements. Only solutions designed in this way can be considered as good solutions, which not only meet the use requirements, but also are suitable for processing and manufacturing.
After comprehensive consideration, U-TRSM designed slewing drives S-I-O-0980, they are light load and thin slewing drives for customers, which have been successfully produced and delivered to customers, our customers have reported that our products are very good to use.
